363-206-285 Detailed Level Procedure: DLP-561
Issue 2, February 2000 Page 5 of 6
DDM-2000 OC-3 MULTIPLEXER
8. Enter term or term COMn command, where n = 1or2.Ifterm is entered
without the COMn option, then COM1 will be selected by default. If after starting
the terminal emulator you see the message Can’t find script <init>,
disregard it.
Response: Two brief messages are printed and you are instructed to
Press any key to continue . . . after the
second message. After you press any key, the terminal
emulator is loaded and the terminal responds as follows:
CTRM ready. (Type Alt-h for help.)
Communications established.
9. Unplug and reseat the SYSCTL and immediately push and hold the FE SEL
and UPD/INIT buttons at the same time until a "P" appears in the FE ID display
(approximately 15 seconds). Software download may take up to 45 minutes.
Response: PC starts download and prints the following message:
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress....
The dots continue to print until program installation is
complete. If using the floppy disks, insert each diskette
when prompted. After installation is completed, the PC
prints the following completion message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets and the terminal is logged off the
system. After approximately three minutes, you can log
into the system.
10. Was response correct?
If YES, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, then continue with Step 11.
11. Did the download start as indicated by the In progress message and rows
of dots?
If NO, then continue with Step 12.
If YES, then proceed to Step 19.