363-206-285 Detailed Level Procedure: DLP-562
Issue 2, February 2000 Page 11 of 12
DDM-2000 OC-3 MULTIPLEXER
34.
NOTE:
The software you downloaded has been loaded as a dormant copy in this
shelf. The original software is still the executing software. The apply:
command must be used at this shelf to install the dormant copy of
software as an executing copy. When the apply: command is executed
during an upgrade from Release 9.1, there is 30-minute delay before the
dormant copy installation begins.
When the apply: command is executed during an upgrade from
Release 11.0 or later, if you do not specify a time and date parameter,
there is a default 15-minute delay before the dormant copy installation
begins. Once the installation begins, the dormant copy is installed in
approximately 10 minutes.
See the Commands and Reports section of Volume 1 of this manual for a
description of the apply: command. The apply: command allows you
to coordinate the software download across the network.
Are you going to use the apply: command at this time to load dormant
version of software?
If YES, then continue with Step 35.
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
35. Use the rlgn:tid command to login again to the remote shelf, then execute
the apply: command.
Response: At the local shelf, a "P" appears in the \f3FE ID\f1 display
when the installation begins.
The SYSCTL resets after the software is installed.
LEDs and FE ID display go off on SYSCTL and User
Panel.
The remote login session is terminated.
After approximately 10 minutes, you can remote login
again to the remote shelf.
36. Was response correct?
If YES, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, then continue with Step 37.
37. Dispatch technician to remote site to perform trouble clearing procedures
and/or install software locally using the procedures of DLP-532.
38. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
DLP-532
To Next Page
Loading...
Need help?
General
