DLP-562: Detailed Level Procedure 363-206-285
Page 10 of 12 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
24. Was response correct?
If YES, then proceed to Step 27.
If NO, then continue with Step 25.
25. Wait approximately 5 minutes for the network to stabilize, exit term, then
repeat this procedure from Step 14. If the second attempt to download
software fails, do Trouble Clearing: TAP-116.Youmayhavetogotothe
remote site.
26. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
27. Wait approximately 5 minutes then verify communications can be
reestablished with far-end shelf using rtrv-map-network: command. Verify
that Comm. Status is good (not FAILED) as indicated by a blank in the
report.
28. Is communication status good between local and remote shelf?
If YES, then proceed to Step 31.
If NO, then continue with Step 29.
29. Dispatch technician to remote site and perform local software download
procedures.
Reference: DLP-532
30. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
31. Use rlgn:tid command to remotely login to far-end shelf.
Reference: DLP-522
32.
NOTE:
If a dormant copy was loaded into the far-end shelf and its release
version is different than the currently executing version, a status alarm
message of dormant/exec code mismatch will appear in the
rtrv-alm: report.
Use rtrv-alm: command at far-end shelf to check for alarm status message
of dormant/exec code mismatch.
33. Does alarm report indicate dormant/exec code mismatch?
If YES, then continue with Step 34.
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
TAP-116
DLP-532
DLP-522