363-206-285 Detailed Level Procedure: DLP-562
Issue 2, February 2000 Page 9 of 12
DDM-2000 OC-3 MULTIPLEXER
21. Enter the command ins-prog:tid or ins-prog:tid,pgmtype=nesw.
Where tid = the target identifier (shelf name) for the far-end
DDM-2000 shelf having the new program installed.
Where pgmtype = the type of software you want to install.
Response: /* Testing For Program Installation... */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =.
22. Was response correct?
If YES, then continue with Step 23.
If NO, then do Trouble Clearing: TAP-116.
23. Enter a y or yes and a carriage return to execute the program. Software
download may take up to 45 minutes.
Response: ABN LED lights on User Panel. A "P." is displayed in
SYSCTL FE ID display in the far-end shelf receiving the
program (for uncompressed executingcopy download, not
if dormant copy is being loaded). PC starts download and
prints the following message:
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress....
The dots continue to print until program installation is
complete. If floppy disks are being used, insert each
diskette when prompted. After installation is completed,
the PC prints the following completion message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets, and the terminal is logged off the
system. The LEDs go off on the User Panel and SYSCTL.
TAP-116
To Next Page
Loading...
Need help?
General
