363-206-285 Detailed Level Procedure: DLP-564
Issue 2, February 2000 Page 2 of 2
DDM-2000 OC-3 MULTIPLEXER
Seat HDSL circuit pack in required slot of LOW SPEED group being equipped.
Response: FAULT LED on HDSL circuit pack lights and may remain
lighted for about 40 seconds and then goes off.
3. Repeat this procedure from Step 1 for each service HDSL circuit pack being
installed.
4.
NOTE:
One protection HDSL circuit pack may be installed in slot 8(P) of each
LOW SPEED group being equipped.
If required, refer to Figure 1 and Table A and set option switches on protection
HDSL circuit pack.
5. If required, install protection HDSL circuit pack into slot 8(P) of low-speed
group being equipped.
6. Install 177A Retainer Cards into all unequipped service DS1 LOW SPEED
slots.
7. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General
