Lucent Technologies DDM-2000 OC-3 User Manual

DLP-566: Detailed Level Procedure 363-206-285
Page 1 of 4 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
Obtain Equipment, Check Software, Prepare and
Connect PC for Software Download
1. Obtain the following equipment:
1. IBM
*
compatible personal computer (PC) running an MS-DOS
†
computer
program operating system, Release 2.1 or later.
2. RS-232 cable to connect PC COM port to User panel CIT port.
NOTE:
The PC may be connected to either the front or rear CIT port, or
remotely through a dial-up modem. If connected to the rear CIT port,
a null modem is required between the RS-232 cable and the rear CIT
port.
3. Working copies of the new system generic program diskette(s).
4. Software Release Description for software being installed.
2. Before beginning the software installation procedure, the following is strongly
suggested:
a. Become familiar with the characteristics and operating procedures of your
PC and the MS-DOS operating system.
Reference: DLP-533
b. Operate laptop PCs on AC power during download procedures.
c. Follow proper procedures in handling the diskette(s) (floppies).
Reference: DLP-533
d. Make working copies and backup copies of the original new generic
program diskettes.
Reference: DLP-534
e. Read the Software Release Description for software being installed.
* Registered trademark of International Business Machines Corporation.
† Registered trademark of Microsoft Corporation.
DLP-533
DLP-534

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English