363-206-285 Detailed Level Procedure: DLP-566
Issue 2, February 2000 Page 2 of 4
DDM-2000 OC-3 MULTIPLEXER
3. Before beginning the software installation, refer to the Software Release
Description for the software being installed for a description of any special
considerations required when installing this version of the software.
4.
NOTE:
If you are using a PC operating in a
Windows
‡
environment, you must
exit
Windows
and restart your PC in
MS-DOS
mode before performing
these download procedures. For example, if your PC is running
Windows
95
you must exit
Windows
by clicking on the Start button, then Shut
Down,thenRestart the computer in
MS-DOS
mode.
Start
MS-DOS
operating system on the PC [DLP-534].
Response: PC displays the prompt (for example, C>, C:\DOS>)
determined by the PC.
5. If you are going to use the PC hard disk to load software to the shelf, copy all
files on the source diskettes(s) (floppies) to a directory on the hard disk (for
example, GEN_1301 for generic version 13.0.1).
6. If you are going to load the software from the hard disk, use the cd command
to change to the appropriate hard drive directory containing the software.
If you are going to load the software from the floppies, use the appropriate
MS-DOS
command (for example, a: or b:)togotothedrivewherethefloppy
disk will be installed.
Response: PC displays the appropriate prompt (A>, B>, C>,
C:\DOS>, etc.) determined by the PC.
Comment: If you are using floppies and get a disk error message,
verify the drive latch is locked and that you have the
proper diskette installed in the drive.
7.
NOTE:
The new generic program may be on many floppy disks. If you are using
the floppy disks, the PC will prompt you to insert disks as needed after
the first disk is installed.
If you are using the floppy disks, insert the first (number 1) floppy disk into the
PC drive.
‡ Registered trademark of Microsoft Corporation.
To Next Page
Loading...
Need help?
General
