363-206-285
Administration and Provisioning
Issue 3 June 2001
8-73
Far-end communication via DCC/IAO
LAN ** ***
DCC identity for OSI subnetworks
** ***
enabled, disabled
userside, networkside
enabled
see command pgs.
set-fecom
set-fecom
CIT security **
CIT timeout (minutes) **
DCC security **
DCC timeout (minutes) **
enabled, disabled, lockout
0-120
enabled, disabled, lockout
0-120
disabled
15
disabled
15
set-secu
set-secu
set-secu
set-secu
Sync Timing Source ‡‡
Sync Output Mode
Sync Timing Source ‡‡
SYNC mode switching
AIS Threshold
Auto. sync. reconfig.
main, fn-c
track¶, lock1, lock2
main-1, main-2, fn-c
revertive, nonrevertive
level 5, level 4, level 3, level 2
enabled, disabled
main
track
main-1
revertive
level 5
disabled
set-sync
set-sync
set-sync
set-sync
set-sync
set-sync
EC-1 alarm level †
EC-1 degrade threshold †
EC-1 port state †
CR, MJ, MN, NA
10
-5
to 10
-9
BER
NMON, AUTO ‡
CR
10
-6
AUTO
set-ec1
set-ec1
set-state-ec1
Feature package **
VT PM, DS1 PM
enabled, disabled disabled set-feat
X.25 packet size †† 128, 256 256 set-x25
L3org (Organization ID)††
L3res (Reserved) ††
L3rd (Routing Domain)
L3area (Area within routing domain)††
L3lv2is (Level 2 router) ††
Refer to command pages of
ent-ulsdcc-l3 in “Section 11.”
000000
0000
0000
0000
disable
ent-ulsdcc-l3
ent-ulsdcc-l3
ent-ulsdcc-l3
ent-ulsdcc-l3
ent-ulsdcc-l3
L4tlif (TARP lifetime parameter) ††
L4aj-(x) (Manual adjacency †† ¶¶¶
parameters)
L4t(x)tm (TARP timer-parameters)
†† ¶¶¶
L4lftm (TARP loop detection buffer
flush timer) ††
L4etdc (Enable TARP data cache)
††
L4tdc(x) (TARP data cache †† ¶¶¶
parameters)
1-65535
See the command pages of
ent-ulsdcc-l4 in “Section 11.”
See command pgs.
1-1440
enable, disable
See command pgs.
100
See command pgs.
See command pgs.
5min
enable
See command pgs.
ent-ulsdcc-l4
ent-ulsdcc-l4
ent-ulsdcc-l4
ent-ulsdcc-l4
ent-ulsdcc-l4
ent-ulsdcc-l4
Table 8-22. Parameters Provisionable via the CIT—Continued
Parameter Range
Default
(Note 1)
Command
(Note 2)
To Next Page
Loading...
Need help?
General
