363-206-285
Administration and Provisioning
Issue 3 June 2001
8-75
†
Parameter can be set for each port.
‡
AUTO means the port or channel is ready to be automatically provisioned via signal
detection.
§
noOverride means read and use switch settings on circuit pack.
¶
Track means the source for timing will be selected from the active received OC-3 Line
specified. It applies to linear 1+1 optical interfaces only.
** This command is available to privileged users only.
††
When security is enabled, this command is available to privileged users only (default is
“disable”).
‡‡
Setting this parameter also affects DS1 output source and DS1 sync output mode. See
set-sync command in Section 11, “Commands and Reports.”
*** Parameters can be set for each channel.
†††
Ring releases. Requires 22D-U/22F2-U/22G-U/22G2-U OLIUs.
§§§
With 24G-U OLIU in main slots.
¶¶¶
(X) indicates multiple parameters. See the command pages of ent-ulsdcc-l4.
To Next Page
Loading...
Need help?
General
