363-206-285
Maintenance Description
Issue 3 June 2001
9-61
Reports 9
This section provides information in reports available through the CIT. For reports
available via TL1/X.25, refer to 824-102-151,
DDM-2000 Multiplexers Operations
Systems Engineering Guide
.
Alarm and Status Report 9
The system provides a report that lists all active alarm and status conditions. The
identity of the condition (circuit pack failure, incoming OC-3 signal failure, etc.) is
included in the report along with a time stamp indicating when the condition was
detected.
See the rtrv-alm command in Section 11, "Commands and Reports," for a
complete list of the alarm and status conditions that are reported by the system.
Provisioning Reports 9
Provisioning reports list the current state of all provisionable options in the system.
See the rtrv-attr-alm, rtrv-attr-cont, rtrv-attr-env, rtrv-crs-
sts1, rtrv-crs-vt1, rtrv-fecom, rtrv-lgn, rtrv-link, rtrv-ne,
rtrv-oc3, rtrv-pmthres-line, rtrv-pmthres-sect, rtrv-pmthres-
sts1, rtrv-pmthres-t1, rtrv-pmthres-t3, rtrv-pmthres-vt, rtrv-
secu, rtrv-passwd, rtrv-ec1, rtrv-oc1, rtrv-sts1, rtrv-sync, rtrv-
t1, rtrv-t3, rtrv-ulsdcc, rtrv-trace-sts1 and rtrv-vt1 commands in
Section 11, "Commands and Reports."
Database Change Transmission to OS 9
All provisioning changes are automatically reported to the OS over the TL1/X.25
interface using REPT DBCHG autonomous messages.
Maintenance History Report 9
A maintenance history report containing the past 500 alarm, status, protection
switching, and CIT (for example, provisioning, loopback request, manual
protection, etc.) events is provided. This summary contains real time and date
stamps indicating when each condition was detected and when it cleared; CIT
events contain a time stamp indicating when the command was entered. Alarm
and status entries in the retrieve history report are not subject to holdoff and clear
delay. See the rtrv-hsty command in Section 11, "Commands and Reports."
To Next Page
Loading...
Need help?
General
