363-206-285
Maintenance Description
9-62 Issue 3 June 2001
State Reports 9
The state reports list the states of all slots, channels, low-speed ports, and OC-1
lines on the system. The rtrv-state-eqpt report includes the protection
switching state ("active" or "standby") and protection switching priority of all
protected lines and equipment in the system. The rtrv-state-path command
includes protection status information for STS-1 paths. See the rtrv-state-
eqpt, rtrv-state-oc1, rtrv-state-sts1, rtrv-state-path, and rtrv-
state-vt1 commands in Section 11, "Commands and Reports."
Equipment Report 9
This report displays the equipage and version information for one or more slots.
Refer to the rtrv-eqpt command in Section 11, "Commands and Reports."
Neighbor Map Report 9
This report shows the Target Identifiers (TID) and Network Services Access
Points (NSAP) of the NEs. The neighbor report lists the TIDs and NSAPs of all
NEs that are immediate DCC and/or IAO LAN neighbors. Refer to the rtrv-
map-neighbors command in Section 11, "Commands and Reports."
Network Map Report 9
The network report lists the TIDs and NSAPs of all reachable NEs (including level
2 ISs) in the local area only, or all reachable level 2 IS NEs in the subnetwork (if
the local NE is provisioned to be a level 2 IS). Refer to the rtrv-map-network
command in Section 11, "Commands and Reports."
To Next Page
Loading...
Need help?
General
