Lucent Technologies DDM-2000 OC-3 User Manual

INIT-SYS 7of4Page INIT-SYS
all addressThe all installationanofendtheatonlyusedis
allthatensuresThissystem.theoverturningbefore
valuesdefaultproperthehavesystemtheinparameters
done.isprovisioningsystem-specificanybefore
!
CAUTION:
addressThe all anonusedbeNOTshould
system.in-service
NOTE:
The init-sys:all toavailableiscommand
only.usersprivileged
underlistedparameterstheallinitializesparameterThis
sysctl following:thePLUS
Loopbacks
opr-lpbk-ec1
opr-lpbk-t1
opr-lpbk-t3
Cross-connections
dlt-crs-sts1
dlt-crs-vt1
ent-crs-sts1
ent-crs-vt1
thresholddegradesignalOC-3
set-oc3
set-ec1
set-sts1 releases)rings(all
set-vt1 releases)rings(all
set-oc1 releases)rings(all
set-ne
thresholdsfailureSignal
set-ec1
set-state-ec1
set-t1
set-t3
(SwitchingProtection manual)
switch-fn
switch-line
switch-ls
switch-sync
OptionsFeature
set-feat
OC-3DDM-2000
2000February2Issue 11-129

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English