Section 4 – REMOTE CONTROL SYSTEM VERIFICATIONS Mini-Crawler Crane M A E D A
4-102 3/2019 MC305C-3
Switching between "Outrigger Extension
mode" and "Outrigger Ground setting
mode" is alternately by each push of the
Speed/Mode button.
Fig. 4-290
Fig. 4-291
6. Push the Start/Reset button and start the
engine.
7. Use the Slewing/No.1 Outrigger operation
lever, to the both "Extend (lower)" and
"Retract (upper)" area, and check that the
No. 1 outrigger follows the lever operation.
Fig. 4-292
Fig. 4-293
8. During the control lever manipulation,
slowly pull and release the Accelerator lever
and confirm that the speed of outrigger
action follows the acceleration ratio.
Fig. 4-294
9. Try other outriggers, No. 2 to 4 by the same
manipulation and confirm that the
outriggers correctly respond to the lever
control.
Lastly, manipulate all the outrigger
operation levers to "Extend (lower)".
10. Use the Speed/Mode button to switch to the
"Ground setting mode".
Fig. 4-295
Fig. 4-296
To Next Page
Loading...
