Maeda MC305C-3 - Instrument Panel Sections

Section 4 – ELECTRIC MOTOR (OPTION) Mini-Crawler Crane M A E D A
4-118 3/2019 MC305C-3
Instrument Panel Sections
Fig. 4-350
1 - Engine and electric motor switch
CAUTION: This section describes only the
switches and monitors that become
available when the machine is powered by
electric motor.
• This section describes the engine and
electric motor switch and monitors.
See "INSTRUMENT PANEL SECTIONS" on
page 4-7 for other switches and monitors.
• Following monitors (five) are not active
when the electrical motor is the output
source.
Fuel gauge, pre-heat monitor, engine water
temperature monitor, engine oil pressure
monitor, battery charge monitor.
Engine and Electric Motor Switch
CAUTION: Ensure that the Inverter unit
power lamp is ON when switching the engine
and electric motor switch to "Electric Motor".
Electric operation is permitted only when the
power lamp is ON.
Use this switch to switch the power output
source of the machine.
• Engine: Push down the switch to the
left.
The engine is designated as a
power output source.
• Electric motor: Push down the switch to the
right.
The electric motor is
designated as a power output
source.
Fig. 4-351
Fig. 4-352