M A E D A Mini-Crawler Crane Section 4 – TRANSPORTATION
3/2019 MC305C-3 4-135
NOTICE: In case machine is automatically
stopped by entering overload area by boom
lowering or boom extending operation, recover
from the overload area by retracting boom, or
lifting boom by keeping the boom lift bypass
switch to ON side.
NOTICE: When working envelope is set, and
operation automatically stops at the boom upper
angle limit or hook height upper limit, boom can
be lifted beyond the limit by using this boom lift
bypass switch. The boom lift bypass switch is to
be used only when in searcher hook mode.
CAUTION:
E-boom and hook may interfere with each
other in RESTRICTED AREA on Rated Total
Load chart.
Do not exceed 30 degrees of boom angle
when E-boom offset position is in SH1.
Fig. 4-393
TRANSPORTATION
Observe the related laws and regulations and
transport the machine safely.
Transport Precautions
Cautions When Loading or Unloading
• Be especially careful when loading or
unloading the Machine because the risks
intervene.
• Select a location that is level and has firm road
surface when loading or unloading the
Machine. In addition, keep enough distance
from the roadside.
• Use the gangplanks under 15 degrees or
smaller angle. In addition, decide the
clearance between gangplanks to meet the
centre of the rubber tracks.
Fig. 4-394
• ALWAYS set the Machine in the "travelling
posture" and securely insert the position pins
(4 pieces) to the outrigger rotary parts before
loading or unloading the Machine.
For more information, see "TRAVELLING
POSITION" on page 4-21.
Fig. 4-395
To Next Page
Loading...
