Maeda MC305C-3 - Periodic Maintenance Procedure

M A E D A Mini-Crawler Crane Section 5 – PERIODIC MAINTENANCE
3/2019 MC305C-3 5-37
Periodic Maintenance Procedure
Initial 10 Hour Maintenance
The following maintenance should be performed
after 10-hour operation, limited to the first
maintenance of a new machine.
• Greasing Machine Units
See "Grease Machine Units" on page 5-39.
Initial 50 Hour Maintenance
The following maintenance should be performed
after 50-hour operation, limited to the first
maintenance of a new machine.
• Replacement Engine Oil and Oil Filter
See "Replace Engine Oil and Oil Filter" on page
5-41.
• Oil Replacement in Hydraulic Oil Tank
See "Replace Oil in Hydraulic Oil Tank" on page
5-51.
• Replacement Hydraulic Oil Return Filter
See "Replace Hydraulic Oil Return Filter" on page
5-46.
• Replacement Hydraulic Oil Suction Filter
See "Replace Hydraulic Oil Suction Filter" on
page 5-47.
• Checking / Adjustment Alternator Belt
Tension
See "Check / Adjust Belt Tension" on page 5-42.
Initial 250 Hour Maintenance
The following maintenance should be performed
after 250-hour operation, limited to the first
maintenance of a new machine.
• Oil Replacement Slewing Reduction Gear
Case
See "Replace Oil in Slewing Reduction Gear
Case" on page 5-52.
• Oil Replacement Winch Motor Reduction
Gear Case
See "Replace Oil in Winch Reduction Gear Case"
on page 5-53.
• Oil Replacement Travelling Motor Reduction
Gear Case
See "Replace Oil in Travelling Motor Reduction
Gearcase" on page 5-54.