Section 4 – REMOTE CONTROL OPERATION Mini-Crawler Crane M A E D A
4-114 3/2019 MC305C-3
Cancel the Micro or Enhanced Speed Mode
Push the Speed/Mode button several times, until
LCD screen indication attains the "Normal".
Fig. 4-343
Setting to the Micro Speed Mode
WARNING! Setting to the Micro speed mode
requires actual crane operations with the
engine running. Before starting the Micro
speed mode setting, always ensure that
nobody except on business is within the
working area.
1. Push the Speed/Mode button several times
so that the LCD screen indicates the "Micro
speed mode".
Fig. 4-344
2. Push the Hook stow/Setting button for at
least 2 seconds.
Indication of "2" in the LCD screen is
high-lighted and it enters into the "Micro
speed mode" setting screen.
NOTICE: The "Micro speed mode" setting is
available while the "2" in the LCD screen is
high-lighted.
Fig. 4-345
3. Push the operation lever to be adjusted and
pull the Accelerator lever slowly.
When the operation speed reaches the
desired maximum speed push the Hook
stow/Setting button.
Fig. 4-346
NOTICE:
• Perform the same process to other operation
levers, respectively.
• In case that you operate two or more levers at
the same time for this setting, note that the
Micro speed rate is established to the ratio of
the fastest operation of all.
It is recommended that the Micro speed shall
be set one by one of each operation lever
• No operation lever provides the Micro speed
unless otherwise set to the Micro speed mode,
beforehand
To Next Page
Loading...
