Grove Published 02-21-2019, Control # 611-05 3-117
TMS9000-2 OPERATOR MANUAL OPERATING CONTROLS AND INDICATORS
Table 3-6 Outrigger Beams Function Screen
NOTE: The top of the remote control corresponds to the
front of the crane (carrier cab is at front). The terms
left and right correspond to the operator’s left and
right sides when looking forward from the front of
the crane.
Outrigger Beams
NOTE: Outrigger controls are only active when the engine
is turned on and the park brake is set.
See Figure 3-174
1. Press the outrigger beams button on the remote
control as many times as needed until the desired beam
screen (1) appears.
2. To RETRACT the selected beams, hold down either
enable button and the left motion button at the same
time. Release both buttons to stop the beams at the
desired position.
3. To EXTEND the selected beams, hold down either
enable button and the right motion button at the same
time. Release both buttons to stop the beams at the
desired position.
4. To exit this screen, press the ESC button on the
remote control. The main screen appears.
Item Indicator Name Description
1
Outrigger Beams
Function
1a - Yellow = beams cannot be operated due to a crane fault
1b - Both left side beams will be operated
1c - Both right side beams will be operated
1d - Left front beam will be operated
1e - Left rear beam will be operated
1f - Right front beam will be operated
1g - Right rear beam will be operated
2 Retract Beams
2a - Green = beams can be retracted with left motion button
2b - Blue = beams cannot be retracted until either enable button is held down
3 Extend Beams
3a - Green = beams can be extended with right motion button
3b - Blue = beams cannot be extended until either enable button is held down
4 Enable Button Status
4a - Green = either enable button held down (operation enabled)
4b - White = both enable buttons released (operation disabled)
To Next Page
Loading...
