Grove Published 02-21-2019, Control # 611-05 3-119
TMS9000-2 OPERATOR MANUAL OPERATING CONTROLS AND INDICATORS
Table 3-7 Outrigger Jacks Function Screen
NOTE: The top of the remote control corresponds to the
front of the crane (carrier cab is at front). The terms
left and right correspond to the operator’s left and
right sides when looking forward from the front of
the crane.
Outrigger Jacks
See Figure 3-175
1. Press the outrigger jacks button on the remote
control as many times as needed until the desired jack
screen (1) appears.
2. To RETRACT the selected jacks, hold down either
enable button and the left motion button at the same
time. Release both buttons to stop the jacks at the
desired position.
NOTE: The front outrigger jack will retract any time a main
outrigger jack is retracted.
3. To EXTEND the selected jacks, hold down either enable
button and the right motion button at the same time.
Release both buttons to stop the jacks at the desired
position.
4. To exit this screen, press the ESC button on the
remote control. The main screen appears.
Item Indicator Name Description
1
Outrigger Jacks
Function
1a - Yellow = jacks cannot be operated due to a crane fault
1b - All four jacks will be operated at same time
1c - Both left side jacks will be operated
1d - Both right side jacks will be operated
1e - Left front jack will be operated
1f - Left rear jack will be operated
1g - Right front jack will be operated
1h - Right rear jack will be operated
1j - Front (stabilizer) jack will be operated
2 Retract Jack
2a - Green = jacks can be retracted with left motion button
2b - Blue = jacks cannot be retracted until either enable button is held down
3 Extend Jack
3a - Green = jacks can be extended with right motion button
3b - Blue = jacks cannot be extended until either enable button is held down
4 Enable Button Status
4a - Green = either enable button held down (operation enabled)
4b - White = both enable buttons released (operation disabled)
To Next Page
Loading...
