Manitowoc Grove TMS9000-2 Series - Page 62

SAFETY INFORMATION TMS9000-2 OPERATOR MANUAL
2-46 Published 02-21-2019, Control # 611-05
The following checklist includes all features that can be
found on Grove cranes. Your crane may not have some
features.
Overload less than 25%
1
Lift Cylinder Inspect for leaking.
2
Turntable
Bearing
Check bolts for proper torque.
See topic in Swing section of
Service Manual.
3
Wire Rope Inspect all for damage.
See topic in Introduction section of
Service Manual.
Overload from 25% to 49%
1
Lift Cylinder Inspect for leaking.
2
Turntable
Bearing
Check bolts for proper torque.
See topic in Swing section of
Service Manual.
3
Wire Rope Inspect all for damage.
See topic in Introduction section of
Service Manual.
4
Hoist/Drums Inspect each for damage.
5
Hoist Brakes Brakes must hold rated line pull.
6
Bearing Main
Boom Pivot Pin
Inspect for deformation, cracked welds.
7
Lift Cylinder-
lower mount
Inspect pin and welds.
8
Turntable Inspect for deformation, cracked welds.
9
Welds Inspect for cracks.
10
Paint
Inspect for cracked paint which could indicate twisted,
stretched, or compressed members.