EasyManuals Logo

Meggitt VM600 User Manual

Meggitt VM600
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
2 - 4 VM600 networking manual MAVM600-NET/E
Edition 9 - February 2018
PROFINET configuration file
CPUM CARD DIRECTORY STRUCTURE AND CONFIGURATION FILES
2.3.2 CPUM cards running firmware version 067 or earlier
For CPUM cards running firmware version 067 or earlier, the Modbus server is configured
using multiple files. These configuration files are listed in Table 2-3 and are stored on the
CPUM.
NOTE: For CPUM cards running firmware version 067 or earlier, only some of the
configuration files listed in Table 2-3 must be modified to change communications
parameters. The configuration file to edit depends on the communications interface
being used.
Refer to the VM600 machinery protection system (MPS) hardware manual for additional
information on the connectors and interfaces supported by a CPUM / IOCN card pair.
2.4 PROFINET configuration file
2.4.1 CPUM cards running firmware version 081 or later
For CPUM cards running firmware version 081 or later, the implementation of the PROFINET
software interface builds on the existing Modbus server by using an additional PROFINET
configuration file. This configuration file is listed in Table 2-4 and is stored on the CPUM.
Table 2-3: Modbus configuration files for CPUM cards
running firmware version 067 or earlier
Modbus
configuration file
Description
mbcfg.2
The configuration file for communication that occurs through
the RS-232 connector on the CPUM card.
This uses a 9-pin D-type connector.
mbcfg.3
The configuration file for communication that occurs through
the RS connector on the IOCN card.
This uses a 6P6C (RJ11/RJ25) connector.
mbcfg.4
The configuration file for communication that occurs through
the A connectors on the IOCN card.
These use 6P6C (RJ11/RJ25) connectors.
mbcfg.5
The configuration file for communication that occurs through
the B connectors on the IOCN card.
These use 6P6C (RJ11/RJ25) connectors.
mbcfg.tcp
The configuration file for communication that occurs through
the 1 connector on the IOCN for the primary network
interface (ETH1) and through the 2 connector on the front
panel of the IOCN card for the secondary network interface
(ETH2), if installed. These use 8P8C (RJ45) connectors.

Table of Contents

Other manuals for Meggitt VM600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Meggitt VM600 and is the answer not in the manual?

Meggitt VM600 Specifications

General IconGeneral
BrandMeggitt
ModelVM600
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals