VM600 networking manual MAVM600-NET/E 7 - 3
Edition 9 - February 2018
Stopping a terminal emulation session using PuTTY
TERMINAL EMULATION
3- Accept the default PuTTY Telnet session options, as shown in Figure 7-2.
4- Click Open to start the PuTTY session, then press the ENTER key.
5- When prompted for a login, type user (the default login), then press ENTER to continue.
For example:
login: user
When prompted for a password, type config (the default password), then press ENTER
to continue. For example:
password: config
The command-line prompt (/usr/user # ) is displayed when the log in is successful.
The terminal command-line and Midnight Commander are used to perform all operations.
7.4 Stopping a terminal emulation session using PuTTY
To close a terminal emulation session using PuTTY, either:
• Type logout (then press ENTER) at the terminal command line.
• Or click Windows Close button (top right).
This ends the terminal emulation session and exits PuTTY.
Figure 7-2: Using PuTTY terminal emulation software –
default Telnet options
To Next Page
Loading...
