7 - 8 VM600 networking manual MAVM600-NET/E
Edition 9 - February 2018
Viewing the contents of a file
TERMINAL EMULATION
5- To close (quit) Midnight Commander and return to the terminal console (command-line
prompt), either press the F10 key (Quit) or use the pointer to click 10 Quit.
6- To restart the CPUM card, at the command prompt (/usr/user # ), type shutdown -f,
then press ENTER to continue. For example:
/usr/user # shutdown -f
The shutdown command shuts down and reboots the CPUM card.
Alternatively, remove and then insert the CPUM card, or turn off and then turn on the
power supply to the VM600 rack, in order to restart the CPUM card.
7- The CPUM card restarts using the new IP address settings.
NOTE: After restarting the CPUM card, it is necessary to re-establish communications with
the CPUM card using the new IP address in the IP Address text box.
7.11Viewing the contents of a file
To view the contents of a text file using PuTTY and Midnight Commander:
1- In a Midnight Commander directory panel, navigate to a file (for example,
version.txt), as shown in Figure 7-6 (left).
The path to the version.txt file is /usr/user/version.txt
2- To view the file using Midnight Commander, either press the F3 key (View) or use the
pointer to click 3 View.
The selected file (version.txt) is displayed in Midnight Commander, as shown in
Figure 7-7.
Figure 7-6: Using Midnight Commander to select a file
To Next Page
Loading...
Need help?
General
