Microplex LOGIJET TC8 - Page 148

148 Panel Functions
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Normal 1:1 Mode
In this mode after tear off or cut no draw back of the unprinted
material takes place. The output volume is at its maximum level.
As a result the first 18 mm of the label are not printable. These
measurements correspond to the distance between printhead
and tear off edge or cutter.
Print head
Tear off edge or cutter
Label, printed
Non-printable
area
1. Print
2. Feed
3. Cut
Rear
print head
Front
print head
Label, unprinted
Please note: A
heads (183 mm) occurs in case of single-sheet printing and
after tear off/cutting the last page of a print job. In addition,
the proportion of label length to the distance of the print
heads can have a negative effect. (It is unfavourable, for
example, if the label/format length is only a little shorter or
much longer than the distance of the two print heads.)