158 Operator Maintenance
__________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Spirit is an easily combustible liquid!
Take notice of the safety instructions for combustible liquids!
Allow the printhead to dry for 2-3 minutes.
6. Install a ribbon (see section 5.2).
7. Swivel the printhead assembly downward and push it down
gently until it clicks into place.
8. Repeat the work steps 2 to 7 to clean the rear printhead.
9.
printing again.
To help keep the printheads clean and to avoid premature wear out
of the printheads, the pr
Moreover it is not allowed to use dusty or dirty print media.
To Next Page
Loading...
