Microplex LOGIJET TC8 - Page 170

170 Operator Maintenance
__________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2

Check to see that slack and wrinkles on the ribbon are
removed completely.
ribbon to ensure the ribbon is running correctly and wrinkle-
free.
17. Lastly tighten the guide plate knurled screws on both ends.
18. Swivel the printhead assembly downward and push it down
gently until it clicks into place.
19.
20. Switch the printer to the ON LINE mode.
The printer is ready for printing again.