Microplex LOGIJET TC8 - Page 175

Troubleshooting 175
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Panel display
Remedies
[HeadNot Found! ]
- one of the printheads is not connected or
faulty.
[Head defectiv! ]
- the printhead is defective. A new
printhead has to be installed.
[High Head Temp. ]
The printhead temperature is too high.
- make sure the consumables have been
loaded correctly
(compare section 5.1 up to 5.3)
[Head Life End! ]
- a new printhead has to be installed
[CutterNotFound! ]
The optional cutter is selected, but not
connected or defective.
- make sure the cutter is installed
correctly.
Also, see section 7.29 Peripheral Device
Activation (Tear Off Edge, Cutter)
- Unselect the cutter, if the cutter was
deinstalled. See section 7.29
[Cutter Error! ]
An error occured during cutter operation.
- check for a paper jam. Remove the
jammed paper.
- reload the consumables (paper)