Microplex LOGIJET TC8 - Page 176

176 Troubleshooting
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Panel display
Remedies
[Punch Error! ]
or
[Sync.Mark Error! ]
- check the position of the sensors (reflective
sensor and transparent sensor).
- set the sensor positions in accordance to
your consumables.
See section 7.2.1. Checking and Adjusting
the Position of the Sensors.
- clean the sensors
See section 8.1.4. Cleaning the Sensors
- Make sure all material pieces are removed
after a paper jam.
See section 9.3. Incorrect Media Transport.
If the remedies above are not successful, please call a Microplex
authorized service engineer.