48 Handling of Consumables
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Fig. 5.2.2.d Sliding the ribbon mandrel completely into the ribbon roll
9. Loosen the free end of the new ribbon roll and fix this end of
the ribbon to the takeup core (using the adhesive end of the
ribbon or a small piece of adhesive tape, if need be).
Fig. 5.2.2.e Fixing the end of the ribbon
10. Slowly wind some ribbon onto the takeup core until the tape
is hidden and the ribbon is securely connected to the core.
To Next Page
Loading...
