Microplex LOGIJET TC8 - Page 91

Panel Functions 91
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
To get access to the Service Functions you have to start the printer in the Service Mode:
The Service Functions can be carried out by a MICROPLEX authorized
operator or a service engineer.
A not trained person is not allowed to carry out this operations.
Please be especially careful when carrying out the following operations to
avoid maladjustments and damaging the printer.
Turn off the printer.
Start the printer in the Service Mode:
Version A (for logiJET TC8 with Touchscreen)
========
Turn the printer off
Put a fingertip on the
touch screen
Turn the printer on
Panel display

[Service Mode ]
  
Notes
Before starting the printer touch the
printer screen (centrally in the upper
area of the touchscreen) with your
fingertip.
Turn the printer on and keep the
finger on the touchscreen for about 1
second, then remove it.
Now the functions of the service menu
are available (compare dashed areas
in the Menu Structure of section 6.6).