Microplex LOGIJET TC8 - Page 92

92 Panel Functions
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Version B (for logiJET TC8 with Display and 6 Function keys)
========
Turn the printer off
+
Turn the printer on
Panel display
[Service Mode ]
  
Notes
Before starting the printer the
ON LINE key and NEXT key have to be
pressed simultaneously.
Turn the printer on and keep the keys
ON LINE/ESC and NEXT pressed until
the messages [Service Mode ] is
displayed shortly.
Now the functions of the service menu
are available (compare dashed areas
in the Menu Structure of section 6.6).
Hint: After performing the steps of Version B some older displays may show a
upside down and inverted image.
So if the display does not work as expected, please perform the following steps
(pay attention to the different chronological order of the steps in this Version C):
Version C (for logiJET TC8 with Display and 6 Function keys)
========
Turn the printer off
Turn the printer on
+
Panel display
[Service Mode ]
  
Notes
(Without pressing any key)
Wait until the display lights up,
then
press the ON LINE/ESC key and NEXT
key simultaneously. Keep the keys
pressed until the messages [Service
Mode ] is displayed.
Release the keys.
Now the functions of the service menu
are available (compare dashed areas
in the Menu Structure of section 6.6).