MIMAKI JV3-160SP - Page 175

– 5.71 –
Error messages
If an error occurs, quit F/W Update Tool software and then turn OFF the poser of the plotter.
Error message Cause Remedy
ERROR COMMAND
POWER OFF
ERROR PARAMETER
POWER OFF
ERROR DATA
POWER OFF
Command error Check whether interface connection is normal.
Turn OFF the power and then turn it back ON.
Parameter error Check whether the file selected on the host computer is for
this device.
Turn OFF the power and then turn it back ON.
Data error Check whether the contents of the file selected on the host
computer are normal and not defective.
Turn OFF the power and then turn it back ON.