– 5.75 –
Data received are not the program file.
Abnormal conditions have arisen on the D-RAM.
Received data is not the program file.
Firmware for after ver5.0 was mistakenly updated to
the main PCB which load firmware for before ver4.0.
The interface board has not been loaded on the device.
Abnormal conditions have arisen on the interface
board.
A error occured in communication between the main
PCB and the interface board.
A time limit exceeded error occured in communication
between the host computer and the interface board.
Data stored in the ROM can not be erased. Replace the interface PCB with a
new one.
Data cannot be written into the ROM. Replace the interface PCB with a
new one.
It is not possible to enter version updating mode. Repeat the version updating from
the beginning.
The received data are not for the interface. Check the version updating file.
Data stored in the ROM could not be erased. Replace the main PCB with a new
one.
Data stored in the ROM could not be erased.
Data could not be written into the ROM.
Data could not be written into the ROM.
Data written into the ROM are wrong.
Data written into the ROM has errors.
Error messages when updating the version on the mechanical side
Error message Cause Remedy
Error message when updating the version on the interface side
Error message Cause Remedy
Error messages that apply to both the mechanical side and the interface side
Error message Cause Remedy
E80 ROM0 ERASE
E81 ROM1 ERASE
E82 h ' ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
E83 h ' ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
E84 h ' ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
E85 ROM HASH
E90 h ' ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
E91 < Skipped No. >
E92 h ' ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
E93 < Skipped No. >
E95 MODE
E97 < Skipped No. >
E98 TRANSE ∗ ∗
E70 FPGA
E71 SD-RAM
E73 < Skipped No. >
E74 TRANS DATA
E75 I/F NONE
E76 I/F INITIAL
E77 I/F BOARD
E78 HOST I/F
Replace the main PCB with a new one.
Check the version updating file.
Update to ver4.1 once then update
again.
Load the interface board on the device.
Replace the interface board with a new
one.
Check the cable and the host computer.