To Next Page

To Previous Page

– iv –

4-2-4. Replacement S-Print head assy (Periodical replacement parts) ........................ 4.14

4-2-5. Adjustment of the head angle ............................................................................ 4.15

4-2-6. Adjustment of the head unit ............................................................................... 4.17

4-2-7. Replacement of S-pump assy and cap slider assy (Periodical replacement) .... 4.18

4-2-8. Adjustment of the station position ..................................................................... 4.20

4-2-9. Adjustment of the cutter height.......................................................................... 4.23

4-2-10. Adjustment of the Linear sensor PCB assy height .......................................... 4.24

4-2-11. Angle adjustment of motor axis ....................................................................... 4.25

4-2-12. Adjustment of the Y-motor belt tension .......................................................... 4.26

4-2-13. Heater Replacement ......................................................................................... 4.28

4-2-14. Replacement Fuse ............................................................................................ 4.36

CHAPTER 5 MAINTENANCE MODE

5-1. Maintenance items ......................................................................................................... 5.2

5-2. Entering into the maintenance mode ........................................................................... 5.3

5-2-1. Entering into the maintenance mode when actuating the plotter......................... 5.3

5-2-2. Entering into the maintenance mode by system parameters................................ 5.4

5-3. Menu of #ADJUST.......................................................................................................... 5.5

5-3-1. PRINTadjust2 ........................................................................................................ 5.5

5-3-2. HEAD ADJUST ................................................................................................ 5.12

5-3-3. WASH ................................................................................................................ 5.13

5-3-4. REPLACE COUNTER ..................................................................................... 5.15

5-3-5. DEFAULT SET ................................................................................................. 5.17

5-3-6. CAPPING ........................................................................................................... 5.18

5-3-7. HEAD ID .......................................................................................................... 5.19

5-3-8. SERIAL NO. ...................................................................................................... 5.20

5-3-9. DEALER NO. .................................................................................................... 5.21

5-3-10. WORM WHEEL .............................................................................................. 5.22

5-3-11. ADJUST EDGE .............................................................................................. 5.23

5-3-12. 500mmSQUARE.............................................................................................. 5.25

5-3-13. SET QUALITY ................................................................................................ 5.27

5-3-14. MEDIA COMP2 .............................................................................................. 5.28

5-4. #TEST items ................................................................................................................ 5.30

5-4-1. CHECK PATTERN ........................................................................................... 5.30

5-4-2. PARAMETER DRAW ...................................................................................... 5.37

5-4-3. ALL PATTERN ................................................................................................. 5.38

5-4-4. X SERVO .......................................................................................................... 5.39

5-4-5. Y SERVO .......................................................................................................... 5.40

5-4-6. XY SERVO ....................................................................................................... 5.41

5-4-7. HEATER TEST ................................................................................................. 5.42

MIMAKI JV3-160SP User Manual

Other manuals for MIMAKI JV3-160SP