MIMAKI JV34-260 - Stamp Setting

3-36
Stamp Setting
It is set whether information, such as printing conditions and a printing date, is output after printing has been
completed.
1
Press the key in LOCAL.
2
Press to select [MACHINE SETUP].
3
Press the key.
4
Press to select [STAMP SETUP].
5
Press the key.
6
Press to select ON/OFF.
7
Press the key.
8
Press the key several times to end the setting.
Output Example
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE S E TUP < ENT >
MACH I NE S E TUP
DRY FAN < e n t >
MACH I NE S E TUP
STAMP SETUP <en t >
STAMP SETUP
STAMP :
OFF
Output image
Stamp (Information below is output.)
• Firmware version/ Ink type/ Printing date and time
• Resolution/ Pass/ Scan direction/ Speed/ Number of
over prints/ Head height/ Media correction value
• Heater temperature/ Environment temperature