Pre-heater
Preheats the media before printing.
(Located inside the platen)
Heavy-duty feeding device
Set a heavy roll medium when drawing with a
heavy roll medium (the medium width is 1.6m or
more).
AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever in the
font of this machine.
USB 2.0 connector
This is USB2.0 interface connector.
Main power switch
Turns on/off the main power for this machine.
Leave the main power turned on to prevent ink
clogging.
Cleaning solution cartridge
Set a dedicated Washings
cartridge (optional).
Roll holders
Putting this into the paper core
(right and left) of a narrow roll
medium (less than 1.6m), hold the
medium. It supports the paper
core of 2 inch and 3 inch.
To Next Page
Loading...
