1-14
Media
Usable media sizes and notes for handling are described.
Usable sizes of media
Caution in handling of medias
Pay attention to the followings for handling of medias.
Model JV34-260
Type of Recommended media Tarpaulin/ FF(Flexible Face)/
Weatherproof PVC
Photo paper/PET/Artificial paper/
Transfer paper
Maximum width 2642mm
Minimum width 210mm
Maximum printing width 2632mm
Roll media
Thickness 1.0mm or less
Roll outside diameter
250mm and less (for small-size media holder, 180mm and less)
Roll weight
100kg and less (for small-size media holder, 25kg and less)
Roll inside diameter 3 or 2 inches
Side printed Side facing outward
Roll end treatment
The roll end is gently fixed to the core with weak-adhesive tape or weak glue
for easy removal.
• Use media recommended by MIMAKI to ensure reliable, high-quality printing.
Set the heater temperature to meet the characteristics of the media.
• Set the temperature of the Pre-heater, Print heater and Post-heater according to the type and
characteristics of the media used.
Automatic temperature setting can be made on the operation panel by setting the profile on the
dedicated RIP. For setting on the RIP, refer to the instruction manual for your RIP.
• Pay attention to the expansion and contraction of the media.
Do not use media immediately after unpacking. The media can be affected by the room temperature
and humidity, and thus it may expand and contract.
The media have to be left in the atmosphere in which they are to be used for 30 minutes or more after
unpacked.
• Do not use curled media.
This may result in paper jamming.
If a regular-sized coated sheet of media is rolled and stored, the coated side has to face outside.
• Be careful to dusts on the edge face of the medium.
Some rolls have dusts contained in the package gathered on the edge surface of the roll. If you use as
it is, the drawing quality may be degraded due to nozzle missing or ink drops. Be sure to set the roll
after removing dusts adhering on the edge face of the roll.
To Next Page
Loading...
