5-19
1
1
1
5
Routine Maintenance
Supplying the Machine with Ink Anew
1
Turn the power of the machine on.
• When the power is turned on, the firmware version is displayed
following [BOOT].
2
Check the ink type to fill, and then press the
key.
• To check the state of the cartridge, press the key. ( P.6-5)
3
Check the ink set (the color) to fill, and then press the key.
• You cannot change the current ink set to another by yourself.
• If you want to change the ink set, contact our service office.
4
Press the key.
5
Set an ink cartridge to the ink station.
• When an ink cartridge has been set, the machine is supplied with
ink automatically.
• The ink station has an insertion slot allocated to each ink color.Set
the ink cartridge according to the cartridge label under the ink
station.
6
When ink has been supplied to the machine
completely, the screen returns to LOCAL.
When the Machine Cannot Be Supplied with Ink in Step 5
When various ink errors including "Almost no ink" and "No ink" occur, ink does not start to be supplied to the
machine.
When ink does not start to be supplied to the machine in "Supplying the Machine with Ink Anew"
Step 5:
(1) Press the key to return to the screen in Step 2.
(2) Press the key to check the state of the ink cartridge.
(3) Correct ink errors ( P.6-5) and repeat the operations from Step 2.
• If an ink cartridge extended the expiry month ( P.3-40) is set, initial ink fill cannot be performed.
Replace the ink cartridge with another one (neither extended nor expired) and perform the initial fill.
• The setting orders of ink cartridges differ depending on the ink set you use. For details,
refer to P.7-4 “Setting orders of ink cartridges”.
• If blurring or missing of characters is found in printing after the machine has been supplied with ink
anew, see "Performing Head Cleaning" ( P.2-34) or "FILL UP INK" ( P.5-16).
To Next Page
Loading...
