2-30
Preparing for the Heaters
Changing the Temperature Settings for the Heaters
You can change/save the temperature settings for the heaters with “Heater” of the setting mode. ( P.3-8)
Here, changing method of the temperature set in the setting mode is explained.
Set the heater temperature according to the characteristics of the media you use.
• The temperature of the heaters has been set to "OFF" as default.
• Appropriate temperature adjustment can be made because the temperature can be adjusted even during
printing.
• It may take several minutes to tens of minutes for the set temperature to be reached, depending on the ambient
temperature.
1
Press the key.
2
Press the key.
3
Press to set the temperature of
each heater.
Heater selecting: Select with
Temperature setting:Set with
• The heater starts to get hot.(The [HEAT] lamp lights in orange.)
4
The heating of the heater stops.
• When the heater temperature reaches the set temperature, the [HEAT] lamp goes off and the
[CONSTANT] lamp lights in green.
5
Press the key to stop heating.
• The screen returns to LOCAL.
• The optimal values of the heater setting differ depending on the ink type to be used. For details, refer
to P.7-4 “Rough standard of heater temperature setting value”.
• The Heater temperature is registrable beforehand according to the media to be used.
P.3-2 “Registering All Printing Conditions Together (Type Registration)”
• The temperature set by the operations above does not reflect the Heater set temperature of the type
registration. The set continues until the power is turned off or the temperature is newly set according
to the following conditions.
(1) Change the type of the setup mode.
(2) Change the Heater temperature of the setup mode.
(3) Designate the Heater temperature from the PC.
• The Heater temperature is controllable at the RIP side if the RIP in use has a function controllable.
(For the setting procedures, refer to the instruction manual of the RIP in use.)
• Use this machine under 20 to 35C. The temperature may not reach the set value due to the
environmental temperature condition.
To Next Page
Loading...
