MIMAKI JV34-260 - Adjusting the Printing Origin

2-28
Changing the printing origin
The position of the printing origin can be changed.
Moving the LED pointer to the changing position and deciding the position.
When the heavy-duty feeding / take-up device is not used
1
In Local, Press .
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by pressing
.
• Select the carriage and media, moving the point with
.
3
After determining the origin, press the key.
• The printing origin is changed.
When the heavy-duty feeding / take-up device is used
1
In Local, Press .
• It enters into the origin setting mode.
2
Press to determine the moving direction of the origin.
• To move to the front of the current origin : Press .
To move to the back of the current origin : Press .
3
Press again to determine the origin of the feeding direction.
• Press same as the keys determined on Step 2. If different key is pressed, only the moving
direction of the origin changes without changing the origin.
• The origin position set above misaligns with the feeding direction of a media by a few centimeters.
Turn [FEED ORIGIN] “ON” in setup mode to fit the origin to the correct light position of LED pointer.
(P.3-3)
OR I G I N SE T UP
0.0 ----
OR I G I N SE T UP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SE T UP
** ORIGIN **
OR I G I N SE T UP
0.0 ----
Move the origin to the front Move the origin to the back
FEED D I RECT I ON SET
[FORE FEED]
FEED D I RECT ION SET
[BACK FEED]
Move the origin to the front Move the origin to the back
OR I G I N SE T u p : FORE
0.0 ----
OR I G I N SETup : BACK
0.0 ----