3-4
Setting Media Correction
Correct the feeding rate of media after the type of media is replaced or the temperature of Heater is changed.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor
printing.
Setting Media Correction
A pattern for media correction is printed and a media-feeding rate is corrected.
1
Set a media. ( P.2-6)
2
Press the key in LOCAL.
3
Press the key.
4
Press to selectone of the user types (1 to 4).
5
Press the key twice.
6
Press the key to print a correction pattern.
• When you have changed the temperature of the heaters, make sure that the [CONSTANT] lamp lights
up and that the preset temperature is reached, and then start the correction.
• On completion of [MEDIA COMP.] during use of a roll media, the media returns to the printing origin.
Then the roll media in the rear of this machine will slacken.
Before printing, take up the slack in the roll media by hand; a loose roll media can result in an inferior
image quality.
• When printing with a take-up device, set the media first and then perform media correction.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is obtained in the boundary between the two bands.
To Next Page
Loading...
