3-2
About User Types
Registering All Printing Conditions Together (Type Registration)
This machine allows you to register printing conditions in each of the user types (1 to 4).
Register a printing condition according to each media that you use in a user type beforehand. When you
replace one medium to another, you can set the optimum printing condition only by changing one user type to
another.
Example of Type Registration
How to Register User Types
1
Press the key in LOCAL.
2
Press the key.
3
Press to select one of the types (1 to 4) and press the key.
4
Select and set each item of "List of Functions".
• For details on how to set each function, see the reference page contained in "List of Functions”.
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user
types.
The underlined has been set as default.
When solvent ink is used. When aqueous ink is used.
Type 1 For Tarpaulin 1 Photo-paper
Type 2 For Tarpaulin 2 For PET 1
Type 3 FF (Flexible Face) For PET 2
Type 4 PVC Synthetic paper
• For each setting item below, you can set it so that the machine may operate according to the value
specified when you printed from your RIP software in the connected host PC.
Set Item : PRINT MODE / INK LAYERS / DRYING TIME / AUTO CUT/ PRE-FEED / MARGIN /
COLOR PATTERN / REFRESH / VACUUM / Feed SPEED LEVEL
• When you operate the machine according to the contents specified with the RIP software, set each
item to “Host” when registering this machine type. When you set it other than “Host”, the machine
operates according to the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value
When no instruction
from RIP exists
*1
Outline
MEDIA COMP. ( P.3-4) -255 ~ 0 ~ 255
Used to print a pattern for
correcting a media-feeding rate
and correct it.
DROP. POS CORRECT -40.0 ~ 0
~ 40.0
Used to adjust the dot position in
go and return printing.
To Next Page
Loading...
