3-12
Setting the Printing Method
In the printing method setting, the following items are set:
• PASS : The pass (printing quality) for printing is set.
• Scanning speed : The scanning speed for printing is set.
• Scanning direction : A printing direction is set.
• Logical seek : ON/OFF of Logical seek is set.
Setting of the PASS (print quality)
1
Press the key in LOCAL.
2
Press the key.
3
Press to select one of the types (1 to 4) and press the key.
4
Press to select [PRINT MODE].
5
Press the key.
6
Press the key.
7
Press to select a PASS (printing quality).
• Set Value : HOST /FAST/STANDARD/FINE
8
Press the key several times to end the setting.
Settable number of passes depending on resolution
• You can set the printing method setting so that the machine may operate according to the value
specified when you printed from your RIP software (RasterLinkPro) in the connected host PC.
• When you give priority to the setting at the RasterLinkPro side, make the setting value “Host”.
• “PASS / SCAN DPEED / SCAN DIRECTION” set in this machine are displayed as “Pass / Fast Print /
Print Direction” respectively in the RasterLinkPro.
• You cannot specify the logical seek at the RasterLinkPro side. When you set this machine to “Host”,
printing will be performed in “LOGICAL SEEK=ON” status.
Resolution (dpi)
Set Value
540 x 720 dpi 540 x 1080 dpi 720 x 1440 dpi
FAST 4 pass 6 pass 8 pass
STD. 7 pass 12 pass 16 pass
FINE 16 pass 24 pass 32 pass
To Next Page
Loading...
