1-10
Connecting Cables
Connecting USB2.0 Interface Cable
Connect the PC and this machine with the USB2.0
interface cable.
Notes on USB 2.0 Interface
When two or more JV34 machines are connected to one personal computer
When two or more JV34 machines are connected to one personal computer, the personal computer may not
recognize all the JV34 machines normally.
Reconnect the unrecognized JV34 machine to another USB port, if available, and check to see if it is
recognized.If the JV34 machine is not recognized by the newly connected USB port, use USB 2.0 repeater
cables available on the market.
Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is connected to
the same personal computer that a JV34 machine is connected to, the USB device may not be recognized.
When JV34 is connected to the personal computer to which an external HDD is connected via USB, the speed
of data output to JV34 may drop.That can cause the head unit to stop temporarily at the right or left end during
printing.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or
our office when the USB2.0 interface is not
attached to the PC.
• Your RIP must be compatible with USB 2.0.
To Next Page
Loading...
