2-6
Setting a Media
This machine can be used with a roll media and leaf media.
For usable medias, refer to P.1-14 “Usable sizes of media”.
Adjusting the Head Height
Adjust the head height according to the thickness of the media you use.
1
Move the carriage to the platen.
• When the device is turned ON
:Execute [ST.MAINTENANCE - CARRIAGE OUT] of the
Maintenance functions.( P.5-5 Step1,2)
• When the device is turned off :
Open the front cover, then move the carriage by hand.
2
Loosen the screw in front.
• Loosen the screws, rotating each by one turn of a standard
screwdriver.
3
Raise the lever of the right side of the carriage.
4
Adjust the height-adjusting lever according to the
media.
• Adjust the position of the lever, referring to “For the
Adjusting Lever and the Range”.
• Set the height-adjusting lever to the highest stage or the
lowest stage.Setting it to the intermediate height, a printing
fault can result.
• Adjust the head height prior to setting the media.If the head height is adjusted after the media is set,
this may cause a media jamming, deterioration of the print quality or head damage.
• The range of the initial head height is adjustable by 2 levels according to the purpose of use.
• The range of the printing height of JV34 is from L range (2 mm/3 mm) to H range (3 mm/4 mm). (Set
to L range 2 mm at shipping)
• If the print quality is set to "Bi-D" ( P.3-14 ), perform "Dot position correction" of the type
registration after the head height is adjusted.( P.3-6)
To Next Page
Loading...
