MIMAKI JV34-260 - Ink Discharge Passage Washing; Washing the PUMP Tube for Ink Discharge

5-10
Washing the Ink Discharge Passage (PUMP Tube Washing)
Wash the ink discharge passage regularly to prevent the head nozzles from clogging due to ink coagulation
inside the passage.
1
Press the key in LOCAL.
2
Press to select [PUMP TUBE WASH].
3
Press the key.
• The carriage moves onto the platen.
• Dry suction operation is performed repeatedly until the washing
work is completed.
4
Open the front cover.
5
Press the key and stream maintenance
washing liquid.
• When you press the key, maintenance washing
liquid streams.
• When you press the key once, maintenance
washing liquid streams, and it stops automatically in 3 sec.
• In addition, if you press the key again while
maintenance washing liquid streams, washing liquid stops.
• While dry suction stops, press the key several
times to stream washing liquid.
• When the following messages are indicated, check the waste ink tank, and then operate it, referring to
P.5-27 “If a Waste Ink Tank Confirmation Message Appears” according to the situation.
• You can stream maintenance washing
liquid with a dropper.
Con f i rm a was t e tan k
Con t i nue< >Exchange
Con f i rm a was t e tan k
Exchange :
e nt
ST . MA I NTENANCE
CARR I AGE OUT < e n t >
ST . MA I NTENANCE
PUMP TUBE WASH < e n t >
ST . MA I NTENANCE
COMPL ET ED : e n t
Front cover