MIMAKI JV34-260 - Setting the DRYNESS FEED

3-32
Setting the DRYNESS FEED
It is set whether a media is fed for it to be dried after printing has been completed.
1
Press the key in LOCAL.
2
Press to select [MACHINE SETUP].
3
Press the key.
4
Press to select [DRYNESS FEED].
5
Press the key.
6
Press to select ON/OFF.
7
Press the key.
8
Press the key several times to end the setting.
When the same data will be printed several times, the dryness feed is performed differently
depending on the specified method in the RasterLinkPro5.
• When “Number of printings” was set on the main screen of the RasterlinkPro5
 When each printing is completed, the dryness feed is performed.
• When “Number of copies” was set in the job editor of the RasterLinkPro5
 After the specified copies are printed, the dryness feed is performed.
The media waste becomes less compared with when specifying in “Number of printings”.
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE S E TUP < ENT >
MACH I NE S E TUP
DRY FAN < e n t >
MACH I NE S E TUP
DRYNESS FEED <en t >
DRYNESS FEED
SETUP :
ON