MIMAKI JV34-260 - Chapter 2: Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
About User Types .........................................2-2
Settings That Can Be Registered in
User Types .................................................. 2-2
Using the Registered User Types ............... 2-2
Workflow .......................................................2-3
Turning the Power ON/OFF ..........................2-4
Turning the Power ON ................................ 2-4
Turning the Power OFF ............................... 2-5
Setting a Media .............................................2-6
Adjusting the Head Height .......................... 2-6
Note for media setting ................................. 2-8
Setting a heavy-duty roll media ................... 2-9
Setting a narrow roll media ....................... 2-20
Narrow take-up device .............................. 2-25
Setting leaf media ..................................... 2-26
Changing the printing origin ...................... 2-28
Preparing for the Heaters ............................2-30
Changing the Temperature Settings for
the Heaters ................................................2-30
Checking the Heater Temperature ............ 2-31
Test Printing ................................................2-32
Test Printing ...............................................2-33
Head Cleaning ............................................2-34
About head cleaning ..................................2-34
Perform head cleaning depending on the
test printing result ......................................2-34
Printing Data ...............................................2-35
Starting a Printing Operation .....................2-35
Stopping a Printing Operation ....................2-36
Deleting Received Data (Data Clear) ........2-36
Cutting a media ..........................................2-37
Chapter 2
Basic Operations