MIMAKI JV34-260 - Print Margin Adjustment

3-17
1
1
3
Convenient use
5
6
Setting Margins
Set a non-printing area along the right and left edges of the media.
The offset value against the standard margin 15mm is set hereupon.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select one of the types (1 to 4) and press the key.
4
Press to select [MARGIN].
5
Press the key.
6
Press to set the left and right
margins.
• Set the margins for the left and the right of the media.
To enable the margins specified in your RIP, select “Host”.
Set Value :HOST or -20 to 75mm (in 1mm increment)
Item selecting : by the keys
Margin setting : by the keys
7
Press the key.
8
Press the key several times to end the setting.
• When you give priority to the setting at the RIP software side, make the setting value “Host”.
• You cannot specify the margins at the attached RIP software (RasterLinkPro). When you use the
RasterLinkPro, if you set this machine to “Host”, printing will be performed in “Margins for right and left
off set value= 0 mm” status.
• Pay attention to that printing may start on the media press if a right and left margin is set to 5 mm or
less when the media press is used in printing.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
MARG I N < e n t >
LEFT : RIGHT
0mm : 0mm
LEFT : RIGHT
HOST : HOST
Left margin
setting
Right margin
setting
[1]
MARG I N < e n t >