MIMAKI JV34-260 - Cleaning and System Setting Management; Automatic Cleaning Configuration; Setting Automatic Cleaning Intervals by Length

3-20
Setting Automatic Cleaning
You can set items so that the head cleaning is automatically performed when printing has been completed for
the set length.
When printing has been completed, the machine measures the length of a medium printed after the previous
head cleaning and performs the cleaning automatically if necessary.
The machine can perform a stable printing operation with its heads always kept clean.
The first cleaning is performed immediately before the first printing after the machine is started. Then
subsequent cleaning is performed every printing on the specified length of media.
When operation interval is 1000 mm (example)
1
Press the key in LOCAL.
2
Press the key.
3
Press to select one of the types (1 to 4) and press the key.
4
Press to select [AUTO CLEANING].
5
Press the key.
6
Press to select ON.
• When selecting OFF, proceed to Step 9.
7
Press the key.
Print length : 1.6 m Cleaning (3rd time)
Print length : 0.0 m Cleaning (1st time)
Print length : 0.8 m No cleaning
Print length : 1.6 m Cleaning (2nd time)
Print length : 0.8 m No cleaning
When five copies of an image 80 cm long are printed in series,
cleaning is repeated before printing each of the 1st, 3rd, and 5th
copies.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
AUTO CLEAN I NG < e n t >
[1]AUTO CLEANING
SETUP :
OFF
[1]AUTO CLEANING
SETUP :
ON
INTERVAL :TYPE
1 000mm :NORMAL